Installation Help

If you have problems with plugging the board in...

Since backplace connectors are fairly tight when new and not all Amigas
have already had IBM cards plugged into them, it may require quite a
bit of pressure to firmly seat your GG2 Bus+ into all 198 pins at once.
Pressing on one end of the card, just a little, then the other, it should
be possible to "rock" the board past the initial resistance.  Once you
start the board in this manner, it should continue to slide into the
backplane with much less pressure than before.  If this technique does not
work, check for physical obstructions in one or more of the backplane slots.


"I don't see the GG2 Bus+ card listed as installed in my machine. What next?"

If you have other AUTOCONFIG cards in your Amiga, ensure that you have
1 megabyte of available AUTOCONFIG space.  If you have already filled
your 8 megabyte limit, the GG2 Bus+ card will not show up because the
Amiga has no place to put it.  It is not necessary to have all 8 megabytes
taken up by a single card.  If you have a 4 megabyte 16-bit memory card
and a 4 megabyte Zorro II video card, you will not be able to add any
other expansion cards which need a chunk of that 8 megabytes.  Normally,
32-bit RAM on accelerator cards does not count against your 8 megabyte
limit.  In addition, Zorro III cards do not require any of the 8 megabyte
space when used in a Zorro III machine such as the A3000 and A4000.

If you do not see the GG2 Bus+ card listed, turn off your machine again 
and make sure that the card is well seated in the slot.  Make sure that
the contacts on your expansion slots are free of dirt and corrosion.  If
you still do not see the GG2 Bus+ board listed as installed, try putting
it into another slot.  If this does not work, try installing another 
Amiga AUTOCONFIG card into your system.  If this card also is not 
recognized, your Amiga may need to be serviced.  If this card is 
recognized, then your GG2 Bus+ board may be defective.  At this point, 
please contact Software Results Enterprises as soon as possible. We will
do all we can to make it right.

Specific installation procedures are available for the different Amiga 
models capable of accepting the GG2-Bus+.  If you have a model 2000/2500 
go to  A2000/A2500 , if you have a model 3000 read 
 A3000 ,  A4000  provides 
instructions for installations on model 4000, and 
 Other , should cover other Amiga models.